|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Hi, thankyou for providing the Nordmende Globetrotter original manufacturer's repair manual. Quality is very good and sharp - the PDF file was comfortably small to download. The only question is: why did it take so long to become ready for download?? Many thanks anyway, I fixed the fault in the radio thanks to the circuit.
regards: Nick
 ;
This was super service.Ordered this manual and was reading the download an hour later
;
as always, rapid and efficient, very good and clear prints
details clearly visible keep going this way!!!!!!
;
I expect a wonderful result as alaways!!!!!!
Usually is much faster....
;
Wow very wonderful and clear!!!! I will always trust them
Left Side Assemblies
Removal &
Exhaust Fan (FM1)
The Exhaust Fan is located on the left side of the printer, just above the High Voltage Power Supply PCA.
1 Unplug the fan connector from the DC Controller (Figure 6-7, callout 1) and
remove the cable from the (2) clips (Figure 6-7, callout 2). 2 Lift the fan out of its mounting, noting the position of the cabling (attaches to lower left outside of the fan body). NOTE Removal of the Card Cage provides easier access to the connector on the DC Controller PCA, especially when reconnecting (Figure 6-7, callout 1).
Figure 6-7
6fusfan 6fusfanwmf
Exhaust Fan To Reinstall: Make sure that the fan is installed in the correct direction (exhaust, not intake). The cables should be toward the outside.
6
Removal and Replacement 6-13
Replacement
|
|
|
> |
|
